EPA 608 Type II · Recovery Requirements · Hard
With post-1993 recovery equipment, what level is required before replacing the compressor on a 150-lb R-410A system?
Answer: B. 0 psig.
- A15 inches of mercury vacuum.
- B0 psig.✓ Correct
- C10 inches of mercury vacuum.
- D25 inches of mercury vacuum.
Why B is right
R-410A is a high-pressure refrigerant (170 to 355 psia at 104°F). Table 1 of 40 CFR 82.156 sets 0 psig for high-pressure appliances holding less than 200 lbs, with any recovery equipment; 10 inHg applies from 200 lbs up (4 inHg with pre-1993 equipment).
More Type II questions
- An R-134a system holds 250 lbs. With post-1993 recovery equipment, what level is required?
- For a repair that isn't major, what level may a high-pressure appliance be evacuated to instead of the Table 1 vacuum?
- What evacuation level does Table 1 require for a very high-pressure appliance, such as one using R-23?
- What evacuation level is required for a Type II appliance with less than 200 lbs of R-22?
- What evacuation level is required for a Type II appliance with 200 lbs or more of R-22?
Go deeper with the study guide EPA 608 Evacuation Levels: The Required Vacuum by Appliance, try the free 10-question test or browse all EPA 608 practice questions.
A practice question written for study, checked against 40 CFR Part 82, Subpart F. It is not an official EPA exam question, and this site is not affiliated with the U.S. EPA.